turnigy 9x transmitter settings

1 post   •   Page 1 of 1
User avatar
notlarc
New Pilot
 
Posts: 31
Joined: Tue Feb 07, 2012 12:09 pm

turnigy 9x transmitter settings

by notlarc » Fri Mar 09, 2012 6:32 pm

Need help with figuring out why the servos are going nuts with the new Tx and rx on the King 4. Bind went fine and all servos hooked into their proper channels, as soon as battery is hooked into the esc all four servos jitter and go to one side. Is there something I missed in the transmitter setup? Should I adjust the end points? I bought an rtf bird and this is my first run at a computerized controller. Any advice is greatly appreciated. Oops never mind should have been in ppm not pcm. Thanks anyway.

1 post   •   Page 1 of 1

Who is online

Users browsing this forum: No registered users and 0 guests

It is currently Sat Aug 01, 2015 3:10 pm